Power On Switch With Pro Controller

[Cat 5 Cable] I am using this switch to power a BZBGear camera and BZB controller. Does exactly what it's supposed to do. It's worth buying Netgear, not the cheaper no name units.

[8 to 90%] Makes using controller software simple as plugging into switch

[ARRI Dovetail] Switch is well built with no need for power.

[7.4 x 4 x 1.65"] I use these to power USW-Flex switches. I have three now. Very affordable. Beats having to buy a pro switch to get BT power.

[10 to 85%] I purchased the hub assembly to tie my 2 Delta pros into my manual generator switch box (6 circuits) back up power to my house. The first one was shipped and I tried it out. It immediately tripped and error 553 showed on both Delta Pros. I called the customer support number and the rep helped me troubleshoot over the phone. She then forwarded the case to the engineers and it was determined that the power hub was defective and a new one was shipped immediately. The new unit works well and now my kitchen, living room and master bed room are powered at the flick of switch. No more running extension cords and unplugging appliances when back up power is needed. I tried to balance loads on the circuits, but if you run the microwave for long it pulls down one Delta Pro quicker than the other. As they discharge I may have to switch Delta Pro Hub inputs to help balance the unit loads. I am pleased with the support and service from ECO Flow and this hub also frees up the 120 volt outlets on the front of the Delta Pros. When I tie in the solar panels I will upgrade to the smart panel and extra Delta Pro batteries..

[24 VDC] This is exactly what I needed for my unifi pro and switch !

[1.515 lb] Manual Switch works without power.

I am using my ShuttleXpress as a remote VFO and switch controller with the Icom RS-BA1 Remote Control Software for use with Icom Amateur Radio Transceivers. Some operators may find the ShuttleXpress in excess of just operating the radio from the computer keyboard, but it makes breaking out your most commonly used functions quick and easy to access. The ShuttleXpress is very well constructed and is very compact and easy to stow in your go bag. A very good alternative to the Icom RC-28.

[16 Bytes] Four POE switch powers my 2 webstream ptz cameras and controller just fine, and the extra non-POE ports are handy for connecting other devices to the network.

[11.1 VDC] Small and very lightweight. Easy to calibrate, but sometimes have to remove battery to re-calibrate. The thin controller that goes with is brilliant. And on/off switch would help. It’s tricky to figure out to push the battery to the side.