Rj45 Splitter Ethernet Cable Sharing

[1x USB-C] Not many laptops come with an RJ45 Ethernet connection anymore. I don't know it's faster than wifi, but it's definitely not slower. Enabled me to use my CAT6a cable to go directly to my router. Just plugged it in my Windows 10 laptop, and it works great.

[RoHS] Short Ethernet cable that works.

[RJ45 Male] A Ethernet cable that works! And it was low cost.

[RJ45 Male] RJ45 plugs solidly connected. Cable is well built with thick copper conductors (I could not measure AWG but clearly thicker than Cat5/5e cables) and shielded. I cut the cable in half and ran the cable but have not connected up as yet - as my new RJ45 connectors (from another company) were not as advertised.

[Windows ] We use these for our timeclocks that are not wifi but have an ethernet cable connection. Works well.

[Paper] Works well for print sharing

[12] Telephone, ethernet, cable and plugs facing every which way. Good stuff.

[RJ45 ] Works great.

[RJ45 ] Does the job for me!

[Up to 1 Gbps] I installed two of these on network cables serving outdoor cameras. The devices are six or eight inches long. There is a white plug in each end that is removed prior to use. The metal nuts fit over an RJ45 connector. A split rubber grommet goes around the cable and a plastic insert with a compressible end also fits over the RJ45. The rubber grommet then fits inside the compressible end of the plastic fitting. The RJ45 then plugs into one end of the surge suppressor, the plastic fitting with the grommet slides into the end of the device to cover the RJ45 and the metal nut then screws on. As you tighten the nut, it compresses the rubber grommet until it is tight around the network cable. I believe this is meant to be water tight, but I mounted mine under cover, so I don’t have firsthand experience with those well that works. The ground strap gets connected to some sort of ground, but there is no explanation of what ground should be used. I assume this should be an earth ground, so I drove a rod into the ground and connected a ground wire from the rod to the strap. Coincidentally, we had a thunderstorm with some very close lightning a day or two after I installed this. The camera reset after one Very close strike. It came back on after a few minutes and appears to work well. However, I was on site a few days later and my Companion Recorder had a flashing red light and was beeping. I have not yet looked at it to see if the two events are related. The network cable runs from the surge suppressor to a 60W PoE injector and then to the Companion Recorder. The PoE injector still works fine and the Companion Recorder is powered through a UPS which also has surge suppression. So the two events could be unrelated.