Stereo Condenser Microphone 3.5 Mm

[Nickel] I have no complaints about this stereo mini 3.5mm cable. It sounds great and seems to be built well.

[4' / 1.2 m] This cable works fine to connect CAD GXL1800 condenser microphone to a 3.5mm audio input jack on an ATEM Mini Pro. Both channels of the ATEM are driven, levels are fine, and the ATEM supplies phantom power to the microphone.

This cable works fine to connect CAD GXL1800 condenser microphone to a 3.5mm audio input jack on an ATEM Mini Pro. Both channels of the ATEM are driven, levels are fine, and the ATEM supplies phantom power to the microphone.

[1' / 0.3 m] Perfect connection I-Pod to treadmill stereo speakers. 1 foot is the short length I was looking for. Believe it or not, these 3.5mm to 3.5mm connectors are not easy to find. The right angle I plug in to the treadmill so the wire lays more flat against the surface . . perfect. Cable works as described and not too expensive.

[Yes] Works great--this cable allows you to convert a male 1/4 stereo jack to a 3.5 mm--I use it to go from an audio mixer to a computer input.

[1] Stereo 3.5mm TRS in, balanced mono XLR out. Perfect for my purposes and passive, so no bulky power supply required. Just does what it says it will.

[±3%] This device turns any 3.5mm stereo into a Bluetooth source. Pairing this device with my Pixel Buds was painless. I bought two on these, one paired to my Buds, one paired to my wife's Buds.

[Eurorack Power] I have been looking for a mini mixer to interface a 3.5 mm stereo source and a XLR mic input. This box is perfect! It is built well and sums both devices to a lowZ mic input and it has a Ground lift to boot.

[Gold] I had been looking for a headphone cable for my keyboard for a while. The only ones I could find were 1/4”-3.5mm adapters which usually compromises the stereo sound cutting in and out. This cable from B&H is amazing...10’ long and hard wired jacks on each end. I am totally satisfied and the package came really quick, even during this Covid 19 pandemic. Great job!

[2] This does more than merely adapting from 3.5mm to XLR. For most PA uses, where one needs to run output from an iPad or other portable device into a mixer, it should be mono and balanced. A splitter adapter cable that goes from XLR to stereo 3.5mm male is ONLY suitable for converting from XLR to dual channel mono out via 3.5mm. The process doesn't work in reverse unless you use a transformer like this that specifically sums the two stereo channels to create a proper mono mix (not just one stereo channel, which may be missing important parts of the mix that are in the other channel). This works perfectly, and I use it several times per year.