Two Drawer File Cabinet Wood

[2] Worth having, especially if you have a wood floor or a glass cabinet.

Worth having, especially if you have a wood floor or a glass cabinet.

[, 3x Flat] I love it! Locking cabinet and drawer keeps my tools safe!

[Tan/Beige] Rather than a need to replace foam in a Pelican case, I've changed one of the file drawers in my desk for storing lenses, flashes and camera body. Once I found the closest match between Pelican case and drawer it was simple to cut each layer to size and place in the drawer. Once this was done the Pick 'N' Pluck system was customized for my gear in about 10 minutes. Way easier than years ago when I would hack out space in a large block of foam!

[10] I installed this into the A/V cabinet in my RV (2008 Tiffin Phaeton) when I upgraded the receiver/amp and was pretty sure I was going to have some heat issues. I made myself a template out of MDF for the fan unit (using the thin plastic sizing template they include), since I couldn't take the cabinet side off to rough it in by hand on the bench. So I needed to clamp it up, auger out a starter hole, then just rout it out (in a few passes). It runs very quietly, even at full speed (which it doesn't typically need to do, I just turned the preferred temp way down to see what it sounded like) I will say -- my package was missing the little wood screws for the controller unit. I just used the included machine screws/nuts instead, but would have preferred the wood screws for that. Overall, I like the thing too much to knock off a star for that, though. I'm sure if called them they'd have sent them.

[19.2 lb] It's a drawer.

[0.65 lb] and it is wood.

[3.2 oz (90.7 g)] Just like what was advertised, it does exactly what I was looking for in a drawer.....

[0.435 lb] perfect for my gun drawer

[14.2 lb] You can never have too much space in a rack drawer.