Wired Headphones For Stereo Receiver

[99.8 dB at 1 mW] I listen to my stereo receiver and also Premium movie channels. My wife and children (two 75# Dobermans) don't like the volume too high. With these headphones, the sound is clear, crisp, and a treat for me. Now when I have the house to myself, I still listen with these new headphones. It's like being there live. Most appreciated.

[> 70 dB ] The best stereo receiver I’ve ever owned! If you want the best, this is it!

[Stereo] They turned my wired headphones into wireless and work great.

[10.695 lb] This is the best personal wired in-ear amplifier. Great spund quality, balanced input or stereo input (configurable). XLR and TRS input... all that you need for an excelent wired personal in-ear monitoring.

[0.175 lb] TR of the 3.5mm end of this cable are both wired to pin 2 of the XLR, so your stereo information gets summed to mono. Pins 1 & 3 of the XLR are connected to shield. XLR connector is by Rean and very nice.

[8 Ohms] These speakers are great for the new stereo receiver. the whole thing was easy to set up. The sound is terrific.

[>-86 dB] This receiver has revitalized my 1980s stereo system by allowing Bluetooth transfer from my Sony Walkman (CD quality) and from an iPhone. When powered the receiver goes into pairing mode--your device remembers this receiver...you are connected. So far there has been no problem with connection or distance from the receiver. As this is my second unit (first attached to another stereo system) I only wish I could rename the unit as it comes up with the same name...only to be identified by the Bluetooth address. If you only have one of these, this will not be an issue. Attachment is simple: connect using RCA supplied cord to your receiver aux input. Having it on a switched plug on the receiver is very convenient. If not, you would have to push the light button to switch it into on mode. It has an auto off after a few minutes of not receiving a signal. It also has an optical connection.

[True Diversity] I usually use wired microphones, but I needed a wireless microphone to work for a media outlet of South America. I use it for outdoor interviews, protests, press conferences etc. I also use it to record voice over. The way that cancels out background noise is amazing, I really did not think it would result as well. Also it never interfered signal. The receiver lets you monitor the batteries. As a negative, the receiver only uses an internal battery. So it will not let you settle for an interview if you run out of energy. Even though not XLR, the sound stays in very good quality. I use a Canon XF 205, 5D mk iii & 7D mk ii.

[128 MB] I've had wired timer remotes for years and many met their end by getting wet, the cord breaking, or the screen fading. This solves a lot of those issues. The receiver is small, it fits in a hot shoe or can be attached to a 1/4-20 screw, and the cord can be changed so I can use it with either of my cameras. Also, since the cord isn't attached, it makes it much easier to pack away into a gadget bag. Two minor issues I've found: 1) like all Godox remotes, it they don't like rechargeable batteries and show them as being low/dead even when they are fully charged. 2) The receiver will change channel sometimes when the batteries are removed/replaced. It's not a huge issue but mine kept switching to channel 10.

[Camera] Finally ordered this to replace my Vello, which is a very good remote, but wired from the camera to the receiver. This does away with the wire, and gives back button focus via the Fn button. It's a winner.